Yarns provides a single part made of two voices. Yarns provides four independent monophonic voices. The voices are independent in the sense that they can play different sequences, respond to different MIDI channels, etc. Yarns provides two independent monophonic voices. Yarns offers a single voice of CV/Gate conversion. This means that there are many different ways of getting these to work together! Each of these configurations are called Layouts. Yarns can handle up to 4 parts, and there are enough CV/Gate outputs for 4 voices. Whenever a note is played on this MIDI channel, it will be dispatched to one of the voices in the group. In its simplest expression, a voice would need only one CV output (to output the note frequency information), and one Gate output (to output the note on/off status) - though additional CV and Gate signals can be produced, for example an extra trigger or a velocity CV.Ī part is a group of voices responding to the same MIDI channel. A traditional monophonic MIDI interface manages only one voice. You can think of a voice as a group of CV and Gate outputs working together to convey information about a single note of music. Three important concepts are used throughout this documentation: voice, part, and layout. Yarns' architecture: voices, parts and layouts More on that in the Latch and keyboard-free operation section! Holding the START/STOP button for a few moments latches the arpeggiator (if it is running), or starts and hold a note.In recording mode, START/STOP and TAP enter a tie step (extends the duration of the previous note onto this step) or a rest (blank step) in the sequence.START/STOP starts and stops the sequencer.REC starts and ends step-by-step recording.To ease navigation, the unabbreviated form of each setting or value scrolls on the display after a few seconds of inactivity.īelow the display are 3 buttons, whose primary functions are to control the sequencer: Yarns' display is small, so settings names are abbreviated into 2 letters code (VR = "Vibrato range"). The typical way of modifying Yarns' settings is to scroll through the list of settings, click the encoder to select one of them, then rotate the encoder to increment/decrement the value of setting, and click again once you are done. ControlsĪt the right of Yarns' display is an encoder which is used to increment/decrement values and scroll through options. The red stripe of the ribbon cable must be oriented on the same side as the "Red stripe" marking on the printed circuit board. It requires a -12V/+12V supply (2x5 connector), consuming 2mA from the -12V rail and 60mA from the +12V rail. Yarns is designed for Eurorack synthesizer systems and occupies 12 HP of space. Yarns embeds an arpeggiator, a note sequencer, and an euclidean pattern generator. Thanks to its flexible architecture, it can manage up to 4 voices of polyphony or up to 4 individual channels. This manual documents the latest version of the firmware, v1.5, which can be downloaded here. Four quadrant multiplication with a vca. Exponential conversion in digital oscillators.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |